IEI Technology NANO-GM45A2, User Manual

Page: 56 / 148

NANO-GM45A2 EPIC SBC
Page 44
Figure 4-5: AT Power Select Jumper Location
4.5.2 Clear CMOS Jumper
Jumper Label:
CLR_CMOS1
Jumper Type:
3-pin header
Jumper Settings:
See
5
Table 4-3
Jumper Location:
See
5
Figure 4-6
If the NANO-GM45A2 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
5
Table 4-3 .