IEI Technology NANO-GM45A2-R10, User Manual

Page: 50 / 148

NANO-GM45A2 EPIC SBC
Page 38
4.3 Unpacking
When the NANO-GM45A2 is unpacked, please check all the unpacking list items listed in
Chapter 3 are indeed present. If any of the unpacking list items are not available please
contact the NANO-GM45A2 vendor reseller/vendor where the NANO-GM45A2 was
purchased or contact an IEI sales representative.
4.4 CPU, CPU Cooling Kit and SO-DIMM Installation
WARNING:
A CPU should never be turned on without the specified cooling kit
being installed. If the cooling kit (heat sink and fan) is not properly
installed and the system turned on, permanent damage to the CPU,
NANO-GM45A2 and other electronic components attached to the
system may be incurred. Running a CPU without a cooling kit may also
result in injury to the user.
The CPU, CPU cooling kit and DIMM are the most critical components of the
NANO-GM45A2. If one of these component is not installed the NANO-GM45A2 cannot
run.
4.4.1 Socket P CPU Installation
WARNING:
CPUs are expensive and sensitive components. When installing the
CPU please be careful not to damage it in anyway. Make sure the CPU
is installed properly and ensure the correct cooling kit is properly
installed.
To install a socket P CPU onto the NANO-GM45A2, follow the steps below: