IEI Technology NANO-GM45A2-R10, User Manual

Page: 114 / 148

NANO-GM45A2 EPIC SBC
Page 102
NOTE:
The setup procedures described below are for Microsoft Windows
operating system users. For Linux system, most setup procedures are
the same with Microsoft Windows except for several steps which is
described in Section B.3 .
B.2.1 Hardware and BIOS Setup
Step 1: Install a hard driver or SSD in the NANO-GM45A2. An unformatted and
unpartitioned disk is recommended.
Step 2: Connect an optical disk drive to the NANO-GM45A2 and insert the recovery CD.
Step 3: Turn on the system.
Step 4: Press the < DELETE > key as soon as the system is turned on to enter the BIOS.
Step 5: Select the connected optical disk drive as the 1
st
boot device. ( Boot Boot
Device Priority 1
st
Boot Device ).
Step 6: Press F10 then "Y" to save changes and restart the computer. Continue to the
next section for instructions on partitioning the internal storage. S te p 0 :
B.2.2 Create Partitions
Step 1: When prompted, press any key to boot from the recovery CD. It will take a while
to launch the recovery tool. Please be patient.
Step 2: The recovery tool setup menu is shown as below.