IEI Technology NANO-GM45A, User Manual, Page: 51 / 128

NANO-GM45A EPIC SBC
Page 39
o
When working with the NANO-GM45A, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the NANO-GM45A DO NOT:
ƒ
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
ƒ
Use the product before verifying all the cables and power connectors are
properly connected.
ƒ
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.2.2 Installation Checklist
The following checklist is provided to ensure the NANO-GM45A is properly installed.
ƒ
All the items in the packing list are present
ƒ
A compatible memory module is properly inserted into the slot
ƒ
The CF Type I or CF Type II card is properly installed into the CF socket
ƒ
The jumpers have been properly configured
ƒ
The NANO-GM45A is inserted into a chassis with adequate ventilation
ƒ
The correct power supply is being used
ƒ
The following devices are properly connected
o
Primary and secondary IDE device
o
SATA drives
o
Power supply
o
USB cable
o
Serial port cable
ƒ
The following external peripheral devices are properly connected to the
chassis:
o
VGA screen
o
Keyboard
o
Mouse
o
RS-232 serial communications device
o
USB devices