IEI Technology NANO-BT Series, User Manual

Page: 75 / 145

NANO-BT EPIC SBC
Page 61
Figure 4-2: iRIS-1010 Module Installation
Step 1: Locate the iRIS module slot on the solder side . See Figure 3-14 .
Step 2: Insert into the socket at an angle . Line up the notch on the RIS-1010 module
with the notch on the connector. Slide the RIS-1010 module into the socket at an
angle of about 20º.
Step 3: Push down until the RIS-1010 module clips into place . Push the other end of
the RIS-1010 module down until it clips into place on the plastic connector.
NOTE:
After installing the iRIS-1010 module, use LAN1 port to establish a
network connection. Please refer to Section 4.5 for IPMI setup
procedures.