IEI Technology KINO-SE-i2, User Manual, Page: 67 / 125

KINO-SE-i2
P a g e 55
WARNING:
The installation instructions described in this manual should be carefully
followed in order to prevent damage to the KINO-SE-i2, KINO-SE-i2
components and injury to the user.
Before and during the installation please DO the following:

Read the user manual:
o
The user manual provides a complete description of the KINO-SE-i2
installation instructions and configuration options.

Wear an electrostatic discharge cuff (ESD):
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.

Place the KINO-SE-i2 on an antistatic pad:
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.

Turn all power to the KINO-SE-i2 off:
o
When working with the KINO-SE-i2, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the KINO-SE-i2 DO NOT:

Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.

Use the product before verifying all the cables and power connectors are
properly connected.

Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.2.1 S O-DIMM In s ta lla tio n
To install a SO-DIMM, please follow the steps below and refer to Figure 4-1 .