IEI Technology IMBA-Q870-i2, User Manual

Page: 83 / 186

IMBA-Q870-i2 ATX Motherboard
Page 67
Step 4: Removing the iRIS-2400 module . To remove the iRIS-2400 module, push both
handles outward. The module is ejected by a mechanism in the socket. Step 0:
NOTE:
After installing the iRIS-2400 module, use LAN2 port to establish a
network connection. Please refer to Section 4.7 for IPMI setup
procedures.
4.2.5 mSATA Card Installation
To install a mSATA card, please follow the steps below.
Step 1: Locate the mSATA card slot . The location of the mSATA card slot is shown in
Chapter 3 .
Step 2: Remove the retention screws . Remove the two retention screws secured on
the motherboard as shown in
7
Figure 4-9 .
Figure 4-9: Remove the Retention Screws for the mSATA Card
Step 3: Insert into the socket at an angle . Line up the notch on the card with the notch
on the connector. Slide the mSATA card into the socket at an angle of about 20º
(
7
Figure 4-10 ).