IEI Technology IKARPC-07A-BT, User Manual

Page: 26 / 108

IKARPC-07A-BT In-vehicle Panel PC
Page 16
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the maintenance of the
IKARPC-07A-BT may result in permanent damage to the
IKARPC-07A-BT and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the IKARPC-07A-BT. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the IKARPC-07A-BT is accessed internally, or any other
electrical component is handled, the following anti-static precautions are strictly adhered
to.

Wear an anti-static wristband
: Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.

Self-grounding
: Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.

Use an anti-static pad
: When configuring the IKARPC-07A-BT, place it on an
anti-static pad. This reduces the possibility of ESD damaging the
IKARPC-07A-BT.

Only handle the edges of the PCB
: When handling the PCB, hold the PCB
by the edges.
3.2 Installation Precautions
When installing the flat panel PC, please follow the precautions listed below:

Power turned off
: When installing the flat panel PC, make sure the power is
off. Failing to turn off the power may cause severe injury to the body and/or
damage to the system.

Certified Engineers
: Only certified engineers should install and modify
onboard functionalities.