IEI Technology ICEFIRE-T10A, User Manual

Page: 47 / 149

ICEFIRE-T10A Mobile Clinic Assistant
Page 33
3.6.2 VGA Monitor Connection
The ICEFIRE-T10A Docking Station has a single female DB-15 connector on the bottom
peripheral interface panel. The DB-15 connector is connected to a CRT or VGA monitor.
To connect a second monitor to the ICEFIRE-T10A, please follow the instructions below.
Step 1: Locate the female DB-15 connector
. The location of the female DB-15
connector is shown in
45
Figure 3-20
.
Step 2: Align the VGA connector
. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.
Step 3: Insert the VGA connector
. Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
ICEFIRE-T10A. See
45
Figure 3-23.
Figure 3-23: VGA Connector
Step 4: Secure the connector
. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector.
Step 0: