IEI Technology HYPER-AL series, User Manual

Page: 30 / 109

HYPER-AL SBC
Page 18
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.
Figure 3-4: Battery Connector Location
Pin Description
1 VBAT+
2 GND
Table 3-4: Battery Connector Pinouts
3.2.1 Buzzer Connector
NOTE:
If you cannot find a good place to put a buzzer on the HYPER-AL, it is
recommended to attach the buzzer onto the system chassis in which
the HYPER-AL is installed.
CN Label: SP1
CN Type: 2-pin wafer, p=1.25 mm
CN Location: See Figure 3-5
CN Pinouts: See Table 3-5
The buzzer connector is connected to a buzzer.