IEI Technology gKINO-DMF-421-R10, User Manual

Page: 67 / 134

gKINO-DMF SBC
Page 53
4.4 M.2 Module Installation
CAUTION:
If an M.2 module is installed in the M.2 slot (M2_KEY_B1), the SATA
port 2 (SATA2) will be disabled. Choose either the SATA2 connector or
the M.2 module for storage.
The gKINO-DMF has one M.2 slot for installing the optional M.2 module especially
designed for the gKINO-DMF. To install the optional M.2 module, please follow the steps
below.
Step 1: Locate the M.2 module slot. See Chapter 3 .
Step 2: Line up the notch on the M.2 module with the notch on the slot. Slide the M.2
module into the socket vertically.
Step 3: Insert two retention screws into the screw holes on both sides of the slot (one on
each side) to secure the M.2 module.
4.5 PCIe Mini Card Installation
The PCIe Mini card slot on the gKINO-DMF allows installation of either a full-size or
half-size PCIe Mini card.
4.5.1 Full-size PCIe Mini Card Installation
To install a full-size PCIe Mini card, please follow the steps below.
Step 1: Locate the PCIe Mini card slot. See Chapter 3 .
Step 2: Remove the retention screw as shown in Figure 4-2 .