IEI Technology GeniSPOT, User Manual, Page: 49 / 71

GeniSPOT Screen Calibration Kit
Page 37
5.5 Run Calibration
Run Calibration sets the calibration of the monitor. The calibration gradually moves from
a black screen, through shades of gray, to a fully white screen.
To Run Calibration , follow these steps:
Step 1: Click Run Calibration in the main window.
Figure 5-17: Run Calibration
Step 2: Place the GeniSPOT in the white block. Don’t move the GeniSPOT until
prompted. Click OK to start the calibration test.
Figure 5-18: Start Calibration
Step 3: The calibration test runs through the screen colors from black to white as shown
in the figure below.
Figure 5-19: Calibration Test
Step 4: Click OK to complete the Calibration Test. S te p 0 :