IEI Technology FLEX-BX200AI, User Manual

Page: 33 / 131

FLEX-BX200AI
Page 17
NOTE:
To temporarily close the HDD cover, turn the lock knob 90°
counterclockwise by hand to secure the cover.
3.5 Removing the Top Cover
WARNING:
Before any internal installation procedures are carried out on the
system, make sure the system is turned off and cooled down for 15
minutes. Failing to turn off the system before opening it can cause
permanent damage to the system and serious or fatal injury to the user.
To access the FLEX-BX200AI internally the top cover must be removed. To remove the
top cover, please follow the steps below.
Step 1: Remove the six retention screws, two on the rear and two on each side.
Figure 3-5: Top Cover Retention Screw Removal