IEI Technology ECW-281B-BTi, User Manual

Page: 35 / 135

ECW-281B-BTi Embedded System
Page 21
Setting Description
Short A-B ATX Mode (Default)
Short B-C AT Mode
Table 3-1: AT/ATX Mode Select Switch Settings
3.6 Hard Drive Installation
One 2.5” SATA hard drive can be installed in the ECW-281B-BTi. The SATA drive is
installed into a hard drive bracket attached on the inside of the bottom panel. To install the
hard drive into the system, please follow the steps below.
Step 1:
Remove the bottom surface. See
Section
765
3.4
.
Step 2:
Remove the hard drive bracket from the bottom surface by removing the four
retention screws that secure the bracket to the bottom surface. (
765
Figure 3-4
)
Figure 3-4:HDD Bracket Retention Screws
Step 3:
Slide the HDD into the bracket and connect the HDD to the SATA cable
connector on the bracket (
765
Figure 3-5
).