IEI Technology ECN-360A-HM65, User Manual

Page: 129 / 154

ECN-360A-HM65 Em b e d d e d S ys te m
P a g e 116
S te p 1:
Hardware and BIOS setup . Refer to Section C.2.1 .
S te p 2: Install Linux operating system . Make sure to install GRUB (v0.97 or earlier)
MBR type and Ext3 partition type. Leave enough space on the hard drive to
create the recover partition later.
NOTE:
If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,
the Symantec Ghost may not function properly.
While installing Linux OS, please create two partitions:

Partition 1: /

Partition 2: SWAP
NOTE:
Please reserve enough space for partition 3 for saving recovery
images.
Figure C-29: Partitions for Linux
S te p 3:
Create a recovery partition . Insert the recovery CD into the optical disk drive.
Follow Step 1 ~ Step 3 described in Section C.2.2 . Then type the following
commands (marked in red) to create a partition for recovery images.
system32> diskpart
DISKPART> list vol