IEI Technology DRPC-330-A7K Series, User Manual

Page: 24 / 74

DRPC-330-A7K Embedded System
Page 14
3.1 Installation Precautions
During installation, be aware of the precautions below:

Read the user manual : The user manual provides a complete description of
the DRPC-330-A7K, installation instructions and configuration options.

DANGER! Disconnect Power : Power to the DRPC-330-A7K must be
disconnected during the installation process. Failing to disconnect the power
may cause severe injury to the body and/or damage to the system.

Qualified Personnel : The DRPC-330-A7K must be installed and operated
only by trained and qualified personnel. Maintenance, upgrades, or repairs
may only be carried out by qualified personnel who are familiar with the
associated dangers.

Air Circulation : Make sure there is sufficient air circulation when installing
the DRPC-330-A7K. The DRPC-330-A7K’s cooling vents must not be
obstructed by any objects. Blocking the vents can cause overheating of the
DRPC-330-A7K. Leave at least 5 cm of clearance around the DRPC-330-A7K
to prevent overheating.

Grounding : The DRPC-330-A7K should be properly grounded. The voltage
feeds must not be overloaded. Adjust the cabling and provide external
overcharge protection per the electrical values indicated on the label attached
to the back of the DRPC-330-A7K.
3.1.1 High Surface Temperature
WARNING:
Some surfaces of the equipment may become hot during operation.
The surface temperature may be up to several tens of degrees hotter
than the ambient temperature. Under these circumstances, the
equipment needs to be protected against accidental contact.
The equipment is intended for installation in a RESTRICTED ACCESS LOCATION.