IEI Technology DRPC-242-ADL-P Series, User Manual, Page: 56 / 167

DRPC-242-ADL-P
Page 40
Setting Description
Open Disabled (Default)
Short Enabled
Table 3-2: ME Override Setting Jumper Pinouts
To update the ME firmware, please follow the steps below
Step 1:
Before turning on the system power, short the Flash Descriptor Security
Override jumper.
Step 2:
Update the BIOS and ME firmware, and then turn off the system power.
Step 3:
Remove the metal clip on the Flash Descriptor Security Override jumper to its
default setting
Step 4:
Restart the system. The system will reboot 2 ~ 3 times to complete the ME
firmware update
3.15.2 Clear CMOS Button
CN Label:
J_CMOS1
CN Type:
Button
CN Location:
See Figure 3-30
CN Pinouts:
See Table 3-3
To clear the CMOS Setup (for example if you have forgotten the password, you should
clear the CMOS and then reset the password), you should
disconnect the RTC battery
and
press the button for about 3 seconds. This will set back to normal operation mode.