IEI Technology DRPC-100, User Manual

Page: 53 / 160

DRPC-100 Embedded System
Page 39
4.3 SO-DIMM Replacement
To install/replace the SO-DIMM modules, please follow the steps below.
Step 1:
Remove the motherboard from the DRPC-100. Refer to Section 3.3 .
Step 2: Locate the SO-DIMM module on the motherboard.
Figure 4-1: SO-DIMM Module Location
Step 3: Release the SO-DIMM module by pulling both the spring retainer clips outward
from the socket.
Step 4:
Grasp the SO-DIMM module by the edges and carefully pull it out of the socket.
Step 5: Install the new SO-DIMM module by pushing it into the socket at an angle
( Figure 4-2 ).
Step 6: Gently push the rear of the SO-DIMM module down ( Figure 4-2 ). The spring
retainer clips clip into place and secure the SO-DIMM module in the socket.