IEI Technology DRPC-100, User Manual, Page: 35 / 160

DRPC-100 Embedded System
Page 21
Figure 3-10: Securing the PCIe Mini Card
Step 5: Reassemble the whole system. Step 0:
3.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The jumpers on the DRPC-100 motherboard are listed in
543H
Table 3-1 . The JP3 and JP4
jumpers are preconfigured for the DRPC-100. Users should not change these jumpers.
Description Label Type
Clear CMOS JP1 3-pin header