IEI Technology DM series, User Manual, Page: 60 / 128

DM Series Monitor
Page 46
5.1 Installation Precautions
When installing the DM series LCD monitor, please follow the precautions listed below:
ƒ
Read the user manual
: The user manual provides a complete description of
the DM series LCD monitor, installation instructions and configuration options.
ƒ
DANGER! Disconnect Power
: Power to the monitor must be disconnected
when installing the DM series LCD monitor, or before any attempt is made to
access the rear panel. Electric shock and personal injury might occur if the
rear panel of the monitor is opened while the power cord is still connected to
an electrical outlet.
ƒ
Qualified Personnel
: The DM series LCD monitor must be installed and
operated only by trained and qualified personnel. Maintenance, upgrades, or
repairs may only be carried out by qualified personnel who are familiar with
the associated dangers.
ƒ
Mounting
: Since the monitor may weigh up to 10 kg (not including a swing
arm or other accessories), please ensure at least two people assist with
mounting the monitor.
ƒ
Air Circulation
: Make sure there is sufficient air circulation when installing the
monitor. The monitor’s cooling vents must not be obstructed by any objects.
Blocking the vents can cause overheating of the monitor. Leave at least 5 cm
of clearance around the monitor to prevent overheating.
ƒ
Grounding
: The monitor should be properly grounded. The voltage feeds
must not be overloaded. Adjust the cabling and provide external overcharge
protection per the electrical values indicated on the label attached to the back
of the monitor.
ƒ
Anti-static Discharge
: The rear panel of the monitor must to be removed to
configure the monitor’s AD board voltage select jumper. When doing so, be
sure the monitor is disconnected from its power source and take all necessary
safety precautions to avoid electrocution and static discharge to the AD board.
The use of a grounded wrist strap and an anti-static work pad is
recommended.