IEI Technology AFOLUX 915A Series, User Manual

Page: 76 / 155

AFOLUX 915 Series Flat Panel PC
Page 62
Clear CMOS jumper (JP9)
COM1 and COM2 RI and voltage selection (JP10)
COM3 RS-232/422/485 selection (JP11, JP12 and JP13)
4.5.1 Touch panel type selection (JP3)
This jumper shouldn’t be changed from factory settings.
This jumper selects the type
of touch panel used in the system.
JP3 Description
4W_5W Short
Table 4-1: Touch Panel Type Selection
4.5.2 CompactFlash® setup (JP5 and JP8)
Two jumpers adjust the CompactFlash® settings.
4.5.2.1 Master/Slave Selection (JP5)
The Master/Slave selection allows the CompactFlash® slot to be setup as either the IDE
master or the IDE slave. If no other IDE device is used in the system, then the setting does
not need to be changed.
JP5 Description
1-2 Master
Open Slave
Table 4-2: CompactFlash® Master/Slave Selection
4.5.2.2 Voltage Selection (JP8)
The operating voltage of the CompactFlash® card is adjusted using the voltage selection
jumper. CompactFlash® cards can operate with both 3 V and 5 V power input.