IEI Technology AFOLUX 915A Series, User Manual

Page: 75 / 155

AFOLUX 915 Series Flat Panel PC
Page 61
Figure 4-3: DDR2 SO-DIMM Module Installation
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
The motherboard comes with ten jumpers. They are listed below.
Touch panel type selection (JP3)
CompactFlash® setup
o
Master/Slave selection (JP5)
o
Voltage selection (JP8)
COM3 RI and voltage selection (JP6)
LCD Type (JP7)
Jumper