IEI Technology AFL3-W15C-ADLP, User Manual

Page: 32 / 156

AFL3-W15C/W19C/W22C-ADLP
Page 16
2.1 Unpacking
To unpack the flat bezel panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat bezel panel PC
has been properly installed. This ensures the screen is protected duri
ng the installation process.
Step 1: Carefully cut the tape sealing the box. Only cut deep enough to break the tape.
Step 2: Open the outside box.
Step 3: Carefully cut the tape sealing the box. Only cut deep enough to break the tape.
Step 4: Open the inside box.
Step 5: Lift the panel PC out of the boxes.
Step 6: Remove the peripheral parts box from the main box. Step 0:
2.2 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do not
proceed with the installation. Contact the IEI reseller or vendor the AFL3
-W15C/W19C/W22C-ADLP was purchased from or contact an IEI sales re
presentative directly by sending an email to
32 6H378 H
sales@ieiworld.com .