IEI Technology AFL3-W15B-H81, User Manual

Page: 46 / 138

AFL3-W15B-H81 Panel PC
Page 32
3.12.2 Panel Mounting
To mount the AFL3-W15B-H81 flat bezel panel PC into a panel, please follow the steps
below.
Step 1:
Select the position on the panel to mount the flat bezel panel PC.
Step 2:
Cut out a section corresponding to the size shown below. The size must be
smaller then the outer edge.
Figure 3-16: AFL3-W15B-H81 Cutout Dimensions
Step 3:
Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4:
Insert a M5*50 screw into the screw hole on the side of the panel mounting
bracket. Then, install the following components onto the screw in sequence.
See
Figure 3-17
.
Sequence Item Photo Instruction
1 Spring Install a spring onto the screw.
2 Nut Tighten a nut until the spring is
compressed enough for plastic cap.
3 Plastic
cap
Tighten a plastic cap onto the end of
screw thread.