IEI Technology AFL3-12A/W15A-BT, User Manual, Page: 32 / 130

AFL3-12A/W15A-BT Panel PC
Page 18

Anti-static Discharge
: If a user open the rear panel of the flat bezel panel PC,
to configure the jumpers or plug in added peripheral devices, ground
themselves first and wear an anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1:
Unpack the flat bezel panel PC.
Step 2:
Install an mSATA module or a HDD.
Step 3:
Configure the system.
Step 4:
Connect peripheral devices to the flat bezel panel PC.
Step 5:
Mount the flat bezel panel PC.
Step 0:
3.4 Removing the Back Cover
To access the AFL3-12A/W15A-BT internally the back cover must be removed. To remove
the back cover, please follow the steps below.
Step 1:
Remove the retention screws from the back cover. Two types of screw are used
for securing the back cover. See the following diagrams for detail. Be aware of
this for reinstalling the back cover.
Figure 3-1: AFL3-12A-BT Back Cover Retention Screws