IEI Technology AFL-xxA-N270 series, User Manual, Page: 49 / 171

AFL-xxA-N270 Series Panel PC
Page 34
4.7 HDD Installation (AF-12A-N270 Only)
To install the HDD into the AF-12A-N270, please follow the steps below:
Step 1:
Remove the plastic back cover. See
Section 4.5
above.
Step 2:
Remove the aluminum cover. See
Section 5.4.2
.
Step 3:
Remove the four HDD bracket retention screws and lift the HDD bracket off the
panel PC.
Step 4:
Attach the HDD brackets to the HDD. To do this, align the four retention screw
holes in the both sides of the HDD bracket with the retention screw holes on the
sides of the HDD. Insert four retention screws into the HDD bracket
(
Figure 4-5
).
Figure 4-5: AF-12A-N270 HDD Retention Screws
Step 5:
Connect the SATA cable to the rear of HDD and the SATA connector on the
motherboard.
Step 6:
Install the HDD into the AF-12A-N270 by aligning the retention screw holes in
the HDD brackets with the retention screw holes on the chassis. Insert the four
retention screws.
Step 7:
Replace the aluminum back cover to the chassis.
Step 8:
Replace the plastic back cover.
Step 0: