IEI Technology AFL-08AH-N270-CR, User Manual

Page: 50 / 115

AFL-08AH-N270-CR Panel PC
Page 36
4.8.2 USB Device Connection
WARNING:
Accessory equipment connected to the analog and digital interfaces
must be in compliance with the respective nationally harmonized IEC
standards (i.e. IEC 60950 for data processing equipment, IEC 60065
for video equipment, IEC 61010-1 for laboratory equipment, and IEC
60601-1 for medical equipment.)
Furthermore all configurations shall comply with the system standard
IEC 60601-1-1. Everybody who connects additional equipment to the
signal input part or signal output part configures a medical system, and
is therefore, responsible that the system complies with the
requirements of the system standard IEC 60601-1-1.
The unit is for exclusive interconnection with IEC 60601-1 certified
equipment in the patient environment and IEC 60XXX certified
equipment outside of the patient environment. If in doubt, consult the
technical services department or your local representative.
There are six external USB 2.0 connectors. To connect a USB 2.0 or USB 1.1 device,
please follow the instructions below.
Step 1: Located the USB connectors
. The locations of the USB connectors are shown
in
Chapter 2
.
Step 2: Align the connectors.
Align the USB device connector with one of the
connectors on the bottom panel. See
Figure 4-13
.