IDTECK Star iCON100SR, User Manual

Page: 76 / 90

SETTING CHANGES p.70
DIP Switch
1=ON, 2=OFF (It shows how the DIP switch on the back of the ICON100 is set.) (First
two for S/W3 and last eight for S/W1)
Input 1-5
0=OFF (Disabled)
1=ON (Enabled)
2=Input Disconnected
If you activate the Cut-Off Check feature for all the input ports in “5.IN/OUT DEFIN
E” from F2 Setup menu, the result of an input port test will change to 222200 (If t
ermination resistors are not connected) or 000000 (If termination resistors are con
nected).
4.8 Communication Test
COMM Test allows you to test communication. Prior to the test, connect the RS232-RX wire
(Black wire with White stripe) and the RS232-TX wire (Red wire with Black stripe) together.
To begin the test, press <ENT>.
If the test is unsuccessful, the LCD will display the “TEST FAILED” message. Press any key to fi
nish the test and try again after powering the iCON100 off and back on.