IDTECK Star Finger007, Manual, Page: 53 / 103

p.46 Setup Menu F1
Baud Rate is the measure of speed in serial communication. As for the communication addr
ess, the baud rate you set here should match the value you set on the software.
Baud Rates of 4800bps, 9600bps, 19200bps, 38400bps, 57600bps and 115200bps are sup
ported, and 9600bps is recommended.
To change the Baud Rate, press <ENT>, select the desired baud rate by pressing <4> or <6>,
and then press <ENT> again to confirm.
If a TCP/IP module is being used, the Baud Rate setting must be the same as the T
CP/IP module setting.
Troubleshooting Communication Problems
Step 1. Match the communication address between the device and the Application
Software.
Step 2. Match the Baud Rate between the device and the Application Software.
Step 3. Ensure that the COM port setting in the Application Software is correct.
Step 4. Ensure that the communication settings in the Application Software are as
follows;
1) Parity Bit: None 2) Data Bit: 8 Bits 3) Stop Bit: 1 Bit
1.4 Reader1 Mode
You can decide which combination of RF card, fingerprint and password verification you wis
h to use on Reader1 (the FINGER007 device itself).
To change the Access Mode for Reader 1, press <ENT>, select the “DESIRED MODE” by press
ing <4> or <6>, and then press <ENT> again to confirm.