IDTECK Star Finger007, Manual, Page: 45 / 103

p.38 Setting Maximum Number of Cardholder IDs
4 Setting Maximum Number of Cardholder IDs
You can set the maximum number of cardholder IDs that can be registered on your FINGER
007. By default, the FINGER007 is set to store up to 10,000 cardholders and 50,000 events
and you can adjust this setting to increase the cardholder capacity at the expense of event
memory.
To change the ID memory setting, enter the Setup Mode (See 2 Entering Setup Mode ), pres
s <F3>, then press <6> 4 times until you see 5.ID memory on the LCD. (See figure 1.) Once t
he 5.ID memory item appears on the LCD, press <ENT>, and press <4> or <6> to select “1000
0/50000”, “20000/40000”, “30000/30000”, “40000/20000” or “50000/10000” (No. of IDs /
No. of events), and then press <ENT> again to confirm.
Prior to changing the maximum number of cardholders, you must clear the event
data from the memory. Because entering the Setup Mode itself generates an event,
you must always initialize the event memory prior to changing the maximum ID nu
mber setting. For additional information on how to intialize the event memory.( re
fer to 12.1.9 Event clear). If you attempt to change the setting with some event da
ta still in the memory, the LCD will display “EVENT MEMORY NOT EMPTY” error m
essage. (See figure 2.)
If you attempt to reduce the ID memory size to a value lower than the current num
ber of IDs stored in the memory, the LCD will display the “ID TOTAL COUNT WRON
G” error message. (See figure 3.) If this is the case, please clear the card data from
the memory. For additional information on how to initialize the card memory (See
12.1.8 Card ID clear.)