IDTECK LX006, User Manual

Page: 39 / 57

p.34 READER MODE
3. Present the Proximity Card you want to delete to the LX006/SR.
4. After the deletion is successfully completed, you’ll hear 4 beeps. If the deletion is not su
ccessful, you’ll hear 2 beeps.
5. If you want to delete more user cards, repeat the steps above.
6. To finish the user card deletion process, present the Master Card to return to the Reade
r Mode.
3 READER MODE
While the LX006/SR is operating in the Reader Mode, the Red LED is lit.
3.1 READER MODE FUNCTION.
In the Reader Mode, the LX006/SR authorizes or denies users who attempt access by presen
ting their cards.
●
If a user is authorized, the LX006/SR transmits the User ID to the controller.
●
If a user fails to be authorized, the LX006/SR transmits the error signal to the controller.
(The error signal is not generated when using ABA Track II format.)
3.2 AUTHORIZATION
If the LX006/SR is operating in the RF-Only Mode or the User Card is registered as a
n RF-Only mode card,
1. Present the registered card to the LX006/SR.
2. If the card is authenticated, a long beep will be generated and the Green LED will be lit.
If the card fails to be authenticated, the LX006/SR output the user ID information accor
ding to the output format setting.
If the LX006/SR is operating in the RF+FINGER Mode and the User Card is registere
d as an RF+FINGER mode card,
1. Present the registered card to the LX006/SR.
2. After the card is recognized, the fingerprint scanner emits red light.
3. Place the registered fingerprint on the scanner.