Troubleshooting
p.37
If the problem persists, please contact service center.
2
The device does not go to setting mode after reading
MASTER ID.
2.1
MASTER ID may have changed.
1.
Change MASTER ID using software.
2.
If you cannot change it using software, see
3.
[Installation of the product] > [System Initialization]
of the manual and initialize the devi
ce.
I.
The first card the device reads after the initialization becomes a master card.
See
[Operation] > [MASTER CARD registration mode]
for more information.
If the problem persists, please contact service center.
3
The device dose not communicate with PC.
3.1
Please check wiring.
See [Communication] of the manual and check if the wiring is good.
In the case of RS232 communication
See
[Communication] > [RS232 Communication Port Connection]
of the manual and check i
f the wiring is good.
Summary of Contents for FINGER006SR
