ID TECH Kiosk V User Manual
Page | 15
8.
Kiosk V Installation
This section provides information on how to install the Kiosk V on a kiosk.
8.1.
Parts List
Verify that you have the following hardware for the installation of the Kiosk V:
•
Kiosk V.
•
USB Cable: a standard USB-C cable could be used for both data communication and power.
ID TECH also supplies these USB-C cables:
•
80185215-001 (Standard Straight, lock-in Connector Cable - USB-A to USB-C)
•
80185213-001 (Right-Angled, lock-in Connector Cable - USB-A to USB-C)
8.2.
Mounting the Kiosk V
Warning:
The RF field of the NFC antenna is sensitive to the proximity of metal. If you are mounting
the Kiosk V in a metal surface, you have three options:
•
Mount with the RF emitting surface of the Kiosk V at least 1cm
forward
of any metal.
•
Mount with the RF emitting surface of the Kiosk V at least 1cm
behind
any metal. This will
reduce the effective range of the antenna inside the Kiosk V.
•
Mount flush with the metal but allow a minimum of 1cm distance from the metal.
Note:
For safety reasons, make sure to mount the Kiosk V at a height no greater than two meters
from the floor.
Kiosk V Part# IDVK-5XX:
