SWC-2000 Command Guide
6
2
Communication Configuration and Specifications
2.1 RS-232C communication
2.1.1 Setting up of RS-232C communication
(1) Connect the SWC and the control device via an RS-232C cable
*
(2) Set up RS-232C communication as follows:
・
RS-232C communication: Baud rate, data bit length, parity check, and stop bit
・
Operation mode of RS-232C communication:
“RECEIVER”
【
Reference: User Guide
】
(3) For the control device, set the same values in the same way as RS-232C communication
(baud rate, data bit length, parity check, and stop bit) in step (2) above
(4) Send a communication command from the control device to the SWC in order to check the control status
of the SWC
*
Use a cross cable to connect the SWC to controller.
Step (2)
Step (1)
RS-232C cable
Step (4)
Communication command
Step (3)
Controller
(Example: PC)
SWC-2000
[Fig. 2.1] Setting RS-232C communication