IDK MSD-402, Command Reference Manual

Page: 81 / 85

MSD-402 Command Guide
81
@GSS Input and output status
Parameter
*6 Error codes are replied in the following order: HDMI output connector / video
output to HDBaseT output connector, HDMI output connector / audio output to
HDBaseT output connector, audio output to analog audio output connector.
Error code Video output status Audio output status
0 Video or audio is output correctly.
1
－ “
@GAM / @SAM Audio output
mute (P.55)
“ is set to “ON”.
2
DDC power is not input. (If input device is not connected, this error
code is displayed.)
3 Video signal is not input. Audio signal is not input.
4
Video or audio output of the source device is muted.
5
Signal with HDCP is input but the sink device does not support
HDCP. (This error code may be also replied during HDCP
authentication.)
6
Source device does not output the required information (packets)
for output of video or audio.
7
Signal that is not supported by
the MSD (dot clock is out of
range) is input. Since compressed audio is input,
audio cannot be output
(Compressed audio can be
output only to sink devices
supporting compressed audio).
8
－
“
@GDO / @SDO Audio output
connector (P.56)
” is set to
Analog audio output or digital
audio output.
9
－ “
@GDM / @SDM Output mode
(P.46)
“ is set to DVI MODE or
sink device that does not support
audio is connected.*
7
A
“
@GSW / @SSW Switching channel (P.20)
” is set to “OFF”.
B
－ －
C Sink device is not connected.*
7
D HDCP is being authenticated.
*7
E HDCP authentication failed.
*7
F Twisted pair cable is not connected.
*8
※
7 Only for HDMI output connector/HDBaseT output connector
※
8 Only for HDBaseT output connector