HDC-TH200 User Guide/Command Guide
49
8.5.5 [ F44 ] Horizontal Active area
You can set horizontal active area.
Setting value
20 to 2900 : 20 dots to 2900 dots
Setting range is limited by setting of display period of horizontal dots.
Maximum value is “display period of horizontal dots”.
【
See: 8.5.7 [ F46 ] Display period of horizontal dots
Notes:
・
When you change this setting by using “ + ” and “ - ” buttons the LED blinks. During the LED is blinking,
press
“SET” button and changes are executed.
If you do not operate more than 10 seconds during the LDE blinking, changes are not executed.
・
If there is no analog
signal, it shows “- - -” and cannot change settings.
8.5.6 [ F45 ] Horizontal start position
You can set horizontal display start position for analog input.
Setting value
20 to 2900 : 20 dots to 2900 dots
Setting range is limited by total number of horizontal dots, display period of horizontal dots, and frequency of
horizontal dots.
Maximum setting value is “total number of horizontal dots - display period of horizontal dots -1”
Minimum setting value is “frequency of horizontal dots + 1”.
【
See: 8.5.3 [ F42 ] The total number of horizontal dots
【
See: 8.5.7 [ F46 ] Display period of horizontal dots
【
See: 8.5.8 [ F47 ] Horizontal sync signal width
Notes:
・
When you change this setting by using “ + ” and “ - ” buttons the LED blinks. During the LED is blinking,
press
“SET” button and changes are executed.
If you do not operate more than 10 seconds during the LDE blinking, changes are not executed.
・
If there is no analog
signal, it shows “- - -” and cannot change settings.
