IDK FDX-S Series, User Manual

Page: 18 / 117

FDX-S Series User Guide
18
[Table 5.1] Features
# Feature Description
Front panel
①
INPUT SELECT button Selects an input.
Loads the crosspoint number (in loading crosspoint mode).
②
OUTPUT SELECT button Selects an output.
③
PRESET LOAD button Enables preset memory load mode.
④
MENU/ENTER button Selects menus, edits, controls, and saves settings.
⑤
Navigation buttons Navigates menu or changes values of adjustable features.
⑥
BACK button Available only in menu page. Goes back to the previous page.
⑦
Front display Displays menus and settings.
Rear panel
⑧
Main power switch
(POWER)
Controls the main power.
⑨
HDMI input connectors Input connectors for HDMI and DVI signals to interface source
devices, such as Blu-ray players
⑩
HDMI cable fixing holes Retain HDMI cables by inserting cable clamps.
⑪
HDBaseT input connector Input connector for HDBaseT signals
Connects to a transmitter over a category cable.
⑫
SDI input connector Input connector for 3G-SDI/HD-SDI/SD-SDI signals
⑬
SDI loop-through output
connector
If the FDX is powered on, the input SDI signals can be output from the
SDI loop-through output connectors.
⑭
HDMI output connectors Output connectors for HDMI and DVI signals, interfaces sink devices
such as LC monitors and projectors
⑮
HDBaseT output
connectors
Output connector for HDBaseT signal
Connects to a receiver over a category cable.
⑯
RS-232C connector 3-pin captive screw connector for RS-232C serial control
⑰
LAN connector For external control by communication commands or web browsers
⑱
ALARM connector Outputs an alert for abnormalities of power supply unit, cooling fan,
internal temperature, and board.
⑲
Power supply connector For use with supplied power cable
⑳
Frame ground Use for bonding chassis to local ground.
An M4 screw is used.
㉑
Fan unit Replaceable fan unit
㉒
Power supply unit
(Primary)
Primary power supply unit for redundant power supply
㉓
Power supply unit
(Secondary)
Secondary power supply unit for redundant power supply
Side panel
㉔
Ventilation holes Prevents internal temperature raise. Do not block ventilation holes.