FDX-08 User Guide
63
8.7.4 Deep Color input [EDID DEEP COLOR]
You can set the Deep Color that is output from the source device.
【
See: 8.7.1 EDID resolution [EDID DATA]
Menu
EDID → EDID DEEP COLOR
Setting for
Each input connector (IN1 to IN8)
Setting value
24Bit: 24 bit/pixel ( 8 bit/component) [Default]
30Bit: 30 bit/pixel (10 bit/component)
36Bit: 36 bit/pixel (12 bit/component)
Notes:
・
Press the SET key to apply the setting.
・
If you set this function to “30 bit/pixel (10 bit/component)” or “36 bit/pixel (12 bit/component)”,
the transmission clock frequency is increased. As a result, noise may appear when a bad-condition cable
or long cable is connected. In such a case, set this menu to “24 bit/pixel (8 bit/component)”.
・
The setting will be applied only if the EDID resolution is set to one of “05” to “24”.
・
Digital scan converter output board and HDBaseT scan converter output board support Deep Color up to
“30 bit/pixel (10 bit/component)”.
・
Since optic I/O boards and optic scan converter output do not support Deep Color, 24 bit/pixel
(8 bit/component) is used.
・
Only channels of input board can be selected in this menu.
Channels in which an SDI input board cannot be selected.
