Part 1 – Introduction
12
Bottom Panel
1
2
3
4
5
1
Joystick Bracket
2
Factory Reset Switch
3
Joystick Input Port
4
RS485 NVR Termination (1)
5
RS485 PTZ Termination (2)
1
Joystick Bracket
Use the provided bracket and screws to attach the
joystick to the network keyboard body. The joystick
can be attached to either the left or right of the
network keyboard body.
2
Factory Reset Switch
Returns all settings to the factory defaults. For more
information, see
Factory Reset.
3
Joystick Input Port
Connect the cable from the joystick. The joystick
cable must be connected while the network
keyboard is off.
4
RS485 NVR Termination (1)
RS485 NVR Termination (1) switch is not
supported.
5
RS485 PTZ Termination (2)
Set the switch ON if RS485 communication
environment is not normal and the connection
is not made while controlling a PTZ camera via
RS485 connection.
Do NOT connect or disconnect the joystick cable
while the network keyboard is on. The network
keyboard must be turned off while connecting
or disconnecting the joystick cable; otherwise, it
may affect the network keyboard or cause it to
malfunction.
Factory Reset
When performing Factory Reset, the settings you
have saved are lost.
You can perform Factory Reset while the network
keyboard is on. Poke a straightened paperclip into
the factory reset switch hole and hold the switch for
about three seconds. After releasing the switch, the
factory reset function is performed. The function also
can be performed remotely using the IDIS Discovery
program. The network keyboard restarts after finishing
the function. Refer to IDIS Discovery Operation Manual
on the installation CD provided with the network
keyboard. For more details about remote factory reset.
