Idis DR-6316PS, Operation Manual

Page: 73 / 136

Part 2 - Configuration
73
● Actions
: Specify which actions to take when Alarm-In
is detected.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out : Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
Video-Analytics_Loitering
● No.
: Select which cameras to apply Loitering to.
●
Minimum Inside Time : An event occurs when object
loiters within the area for a set period of time after the
object has been detected.
●
Area : Set the area to monitor the movement of
objects.
● Ignore Condition
: Set the condition to ignore them
when the events occur.
–
Ignore Condition
: The system does not produce
event log entries or issue remote notifications
regarding event for the spcified time after the initial
event was detected. Set the value between 1 sec
and 5 secs or choose Never.
Ignore Condition
does
not affect Loitering recording.
–
Use Ignoring Time
: Loitering detection will be
disabled during the specified time.
● Actions
: Specify which actions to take when
Tampering is detected.
– Record : Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to
Event
or
Time & Event
mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ : Moves the PTZ camera to a specific preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.