Part 2 - Configuration
68
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
●
Ignoring Interval
: The system does not produce
event log entries or issues remote notifications
regarding audio detected during the specified time
following the initial audio detection. Set a value
between 1 sec and 5 secs or choose
Never
.
●
Use Ignoring Time
: Select
Time Setup
to specify the
audio detection ignore time. Audio detection will be
disabled during the specified time frame.
Camera System_Camera Fan Error
The event occurs when the fan has stopped in the fan
mounted camera.
●
No.:
Select which cameras to apply Fan Error to.
●
Actions:
Specify which actions to take when a Fan
Error event occurs.
–
Record:
Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out:
Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify:
Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ:
Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
•
In order to use the Callback feature, the NVR must
be registered on the remote program.
•
In case of the camera that not supports camera
system event, the camera system feature will be
disabled.
