Part 1 – Introduction
11
1
2
3
4
5
6
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
3
Plug in the network cable.
1
2
3
4
5
6
4
Connect the plug terminal to the RJ45 jack.
1
2
3
4
5
6
5
Push the waterproof cap body and cap into the RJ45
jack and rotate it.
1
2
3
4
5
6
6
Lock the waterproof cap into the waterproof cap
body.
Not pulling the cable back may cause water to seep in
and damage the product.
Installation
•
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
•
Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Screw the mounting bracket to the wall or ceiling by
using screws(4) and bushings(4) provided with the
camera.
2
Adjust the camera angle by bending the stand. After
fully assembling the joint screws, unscrew it 2 ~
2.5 turns again and move the cover of the joints of
the left 3 places slightly. (The screws should not be
completely released to prevent it from falling.) After
adjusting the direction of the camera, turn the screw
clockwise to secure it completely.
M4
Screw
