Part 1 – Introduction
14
Installation
•
Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall off if the wall or
ceiling is not strong enough to support its weight.
•
Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be affected
adversely.
1
Use the screws, anchor provided with the camera to
secure the install bracket on a wall or a ceiling.
Use the provided guide pattern to check the
distance between the screws.
2
Detach the protrusion part from the cable rubber
along the dotted line.
3
Make the LAN cable go through the cable rubber
using the protect connector.
It is recommended to use lubricant to move the LAN
cable smoothly.
4
Pull the cable slightly and arrange the rubber as
shown below.
To pass through a thin cable or more than two cables,
it is advised to finish it using silicon to make sure
waterproofed perfectly. (Silicon finishing part — refer
to bottom image.)
