iDirect iQ LTE Series, Installation, Support, And Maintenance Manual

Page: 32 / 70

18 Installation, Support, and Maintenance Guide
iQ LTE Satellite Router
Installation Steps at a Glance
• Ensure the iQ LTE Satellite Router has adequate ventilation.
• Do not install the iQ LTE Satellite Router on the floor.
• Select a suitable dust free location.
• To protect the equipment and to avoid personal injury, observe the physical and
environmental considerations below when installing an iQ LTE Satellite Router:
•
Ventilation
A single-core protective vent on the back of the chassis provides pressure equalization
and allows reliable operation of the product. To protect the chassis from overheating
do not place this product in a built-in installation, such as a bookcase or enclosed
rack, unless proper ventilation is provided or the manufacturer instructions have been
followed.
• Power Cord Protection
Route power supply cords so they will not be walked on or pinched; pay particular
attention to cords at plugs, convenience receptacles, and at the exit points.
• Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles.
• Heat
Do not place the iQ LTE Satellite Router near heat sources, such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.
• Attachments
Do not use attachments unless recommended by the manufacturer.
• Grounding
Never defeat the ground conductor or operate the equipment without a suitably
installed ground conductor. Contact the appropriate electrical inspection authority or
an electrician if it is uncertain that suitable grounding is available.
4.1.2 Installation Checklist
1. Unpack the router according to the unpacking instructions in Section 4.3, Unpacking
iDirect Equipment on page 19 .
2. Account for all components for the installation. A typical list is given in Section 4.4,
Components Typically Included in an Order on page 20 .
3. The recommended tools should be available for installation. See Section 4.2, Tools and
Supplies Required for Installation on page 19 .
4. Prepare the coax cables as directed in Section C.1, Coax Cable Preparation on page 39 to
connect to RX IN and TX Out.
NOTE: The iQ LTE Satellite Router is designed to be installed in a sheltered
environment per environmental specifications. See Section 2.1, on page 5 .
NOTE: Where applicable, mating connectors must be prepared for
installation. See Appendix C, Cable Preparation on page 39 and Appendix D,
DC Power Supply Installation (for routers with DC power supply options, only).