iDirect iQ Desktop+, Installation, Support, And Maintenance Manual

Page: 27 / 52

Installation, Support, and Maintenance Guide 15
iQ Satellite Router
Tools and Supplies Required for Installation
5. Prepare the Ethernet cable(s) and connector(s) as described in Section B.2, Ethernet Port
Pinouts on page 30 . For connection to the management interface, use ETH 2 port with an
RJ-45 cable as described in Section B.2.2, on page 31 .
6. Monitor front and rear panels during startup. See Section 3.1, iQ Satellite
Router Front LEDs on page 8 and Section 3.3, iQ Satellite Router Rear Panel
Description on page 10 .
7. Prepare PC for iQ Satellite Router connection as specified in Section 4.5,
Preparing the PC for Connection to the iQ Satellite Router on page 16 .
8. Login to the user interface using the PC.
9. Install the firmware and configure the satellite router as specified in Section 4.7,
Configuring the iQ Satellite Router on page 17 .
10. If the router needs repacking or maintenance see Chapter 5 on page 19 .
11. When the iQ satellite Router is physically installed, the firmware and
configuration of the satellite router need to be completed. Refer to the
iDX Satellite
Router Installation and Commissioning Guide for the release of software installed on the
system and for instructions.
4.2 Tools and Supplies Required for Installation
Appendix A, Tools Needed on page 23 specifies recommended tools and supplies used when
installing the iQ Satellite Router.
4.3 Unpacking iDirect Equipment
The satellite router and related equipment may be shipped in one or more shipping
containers. Once all of the boxes have been received, perform the following tasks:
•
Confirm the boxes are facing upward (refer to the box orientation arrows on the shipping
container)
• Inspect all shipping containers
• If any damage or other signs of mishandling are evident, inform the carrier and either
iDirect or the reseller
• Remove the tape and any exterior covering from the box lid
Save the iQ Satellite Router shipping boxes after unpacking the system. These boxes
will be needed in the event of moving or shipping the system in the future. See
Section 5.4,
Repacking the iQ Satellite Router on page 21 for repacking information.
Remove items from the box only as needed. Verify all of the proper iQ Satellite
Router components and accessory items listed in the order have been received, including the
optional equipment ordered. See
Section 4.4, Components Typically Included in an Order on
page 16 .