Aspect 100RTL Q-CARD
SETUP/PATIENT PREPARATION:
Moving table:
1) Unlock front and rear casters.
2) Position table to desired location.
3) Secure table mobility by locking front and rear casters.
AC Power:
1) Plug power cord into properly grounded outlet.
2) Protect power cord from damage by casters or other
equipment.
Controls:
1) Emergency Stop Pushbutton disables all tabletop motion
control when engaged.
2) Ensure that hand and foot controls are connected to table.
3) If tabletop motion controls fail to operate, make sure that the
Emergency Stop Pushbutton is NOT pushed in.
4) Actuate controls to ascertain that power is present and table
movement functions properly.
EMERGENCY PROCEDURES:
Stop Tabletop motion:
•
Press Emergency Stop Pushbutton until it is fully engaged.
AC Failure:
•
Internal battery allows tabletop motions to function. Return
tabletop to proper position to unload patient.
CPR:
Return table to level, center tabletop to minimize
overhang and lower table position to a comfortable
height to perform CPR.
CLEANING AND STORAGE:
1) Unplug power cord and wrap it
around the cord holder.
2) Push in Emergency Stop
Pushbutton.
3) Set caster lock pedals to
LOCK position.
4) Clean and disinfect table.
WARNING! Read operator
manual prior to use
Scan to
Access
User
Manuals
Online
CONNECTION POINT FOR
HAND OR FOOT CONTROLS
CONNECT HERE
EMERGENCY
STOP
PUSHBUTTON
CASTER LOCK
PEDAL
POWER CORD
HOLDER
POWER
CORD
IMAGING END OF TABLE
