Operator Manual
Aspect 100-4
L100-3316 Rev. A
17
9.2.
Patient Restraint Straps.
The Patient Restraint Straps can be
used in two different ways depending
on where the strap is to be located
along the length of the Tabletop. If the
strap is to be used on the end of the
table that has the two long accessory
rails, then the whole strap drapes over
the Tabletop, hangs down between the
rails and the tabletop and wrapped over
the outside of the rails to meet over the
top of the table. If the strap is to be
used along the rest of the tabletop,
slide the strap over the end of the table
with the thin part of the strap over the
Tabletop and the thicker part under the
tabletop. The ends of the strap meet
over the top of the table and connect
with hook and loop fasteners.
WARNING!
Strap configuration is recommended; however, patient
restraint is a case-by-case condition. Please refer to
the facility’s policy on restraining a patient.
