Installation and Maintenance Guide for IDI Suspension System mounted to Canon DST-1000A Rails
L240-1429 REV A Image Diagnostics, Inc.
Page
26
7.
Check the pad attached to the underside of the monitor mount. If there is any damage to the
pad or if the pad is not properly attached to the unit, it must be replaced. See Figure 23.
The procedures mentioned in these instructions are based on the recommendations of HHS, I.E.C.,
etc.
In cases of increased wear or where severe working conditions exist, maintenance checks should
be made at shorter than the specified intervals.
Should any control or indicator fail to operate properly, do not use the equipment until it has been
repaired. Operating equipment with defective components may expose the operator or the patient
to safety hazards.
The manufacturer strongly recommends that a maintenance program be initiated and that a
maintenance record be kept detailing dates and nature of maintenance performed, the name of the
service engineer, and any other relevant information.
WARNING!
Removal of any hardware requires re-assembly with
Loctite #242 or equivalent (depending on hardware
size) following manufacturer's instructions.
H. CUSTOMER SUPPORT
For technical assistance, be sure you have the complete model and serial number before
contacting the local or national service office.
Customer Support
Image Diagnostics, Inc.
310 AUTHORITY DRIVE
FITCHBURG, MA 01420
USA
Or call IDI at (978)829-0009 or send fax to (978)829-0027 or call Toll Free at (877)304-5434
Pad
Figure 21