Installation and Maintenance Guide for IDI Suspension System mounted to Canon DST-1000A Rails
L240-1429 REV A Image Diagnostics, Inc.
Page
20
6.
Position shaft/cable handling assembly created from steps 1-5 to desired location along length
of rail. Torque standoffs to nut plates approximately 35 to 50 inch-pounds (4.2 to 6.0Nm) and
tighten socket head cap screws. Use Loctite #242 on threaded hardware.
CAUTION!
Over tightening the standoff will weaken or
break the thread connecting the standoff to the
nut plate causing attached components to fall.
DO NOT loosen or adjust the exposed length of
the setscrew on the standoff.
DRESS CABLES
1.
When the monitors have been properly installed, it is recommended that the cables run through
the pivot tube as shown in Figure 14. Attach 2in. (5cm) Flexaust hose (provided) to pivot tube
and route underneath the arm via the cable hose clamps. Rotate entire system to maximum
positions. The system should not drift from any position. If it does, check that enough cable
has been left to allow freedom of motion.
36" [914mm]
HANDLING ASSEMBLY
MOBILE CABLE
48" [1220mm]
BETWEEN COMPONENTS
APPROX. LENGTH OF CABLE HOSE
*
[400mm]
15 3/4"
47" [1200mm]
*
LOCATIONS MAY REQUIRE SOME VARIATION
ACTUAL ROOM LAYOUT AND EQUIPMENT
CONFIGURATION
OPTIMUM CABLE HOSE
HANDLING ASSEMBLY
STATIONARY CABLE
*
Figure 12
ARM
PIVOT TUBE