Installation and Maintenance Guide for IDI Suspension System mounted to Canon DST-1000A Rails
L240-1429 REV A Image Diagnostics, Inc.
Page
13
INSTALL MONITOR MOUNT
NOTE TO INSTALLER: It is
important that the load be
balanced on the monitor
mount. Consider any
differences in size and weight
of the monitors. Refer to
Figure 6 for steps 1-6.
1.
Remove wireway cover.
2.
Insert rotation bearing into
the pivot plate on the top of
the monitor mount.
3.
Install the thicker of the two
thrust rings onto the rotation bearing from inside the monitor mount frame.
4.
Install the thinner stainless-steel thrust ring onto the rotation bearing from inside the monitor
mount frame.
5.
Install six socket head cap screws with lock washers through the rotation cap, then through the
rotation bearing and into the pivot tube of the core assembly. Use Loctite #242 on hardware.
6.
Apply a very little amount of Loctite #242 to six set screws and install them into the threaded
holes on the rotation cap. Install the set screws until they bottom out. They may be tightened
or loosened later to adjust rotational resistance.
WARNING!
Failure to securely attach hardware may result
in serious injury to patient, user, and damage
to equipment.
Figure 4